I bought another temperature unit, a Capidi RAR801 and I did also try that one at home before I moved it to my country house, and it worked. And now the spooky thing happens. The new unit was first shown in country house location in telldus live, and worked good but the next day it stops to update the temperature. So I try to edit my sensors, but the sensor was located at my home location? So I bringed the sensor home and it was working at home one day. Then it stopped to update.
I have now tested everything, I have moved the Telstick, I have reset the sensor, the sensor is sending signal to the indoor display so there is no problem with the sensor.
Next step was to try to update the firmware in the Telstick. But it doesn’t work. I have moved the Telstick to different network, different computers always connected with cables, in same router in different switch, with different power supplies. I can ping to the ip address but the Telstick flasher can’t find any Telstick. So the Telldus live say that I have two sensors at my home location even if there are none.
