Tellstick Net & Intertechno impulseswitch

[ferhub]

Hi,

i recently installed my Tellstick Net and everything works fine so far, with one exception:
I have an CMR-1001 impulseswitch to switch my lights in my corridor (there are 6 key buttons which activate a latching relay)
Normally, the switch is activated by pressing and holding the on button on the intertechno remote and switches off wenn you release the button.
Telldus Live has only on/off switches an dim switches. So i created it as on/off switch, but the time the switch is activated is too short.
Is there a way to extend the time the on signal is sent?

Thanks for your help

[micke.prag]

There is currently not possible to extend the time the signal is sent

[ferhub]

then, is this feature planned or does it come in one of the next firmware?