free30 wrote:Thanks for the new offset-version.
I find that the battery reporting on the humidity is 50% where as with the mandolyn firmware it always give a number over 100%, which is easy to interpret. Obviously not a humidity report.
The reason for having different presentations is that telldusd has a sanitycheck of the humidity data in the fineoffset protocol. If the humidity is over 100% it throws away the package. I was forced to change the span.
free30 wrote:
I used the Offset version as otherwise the sensor reports as the same ID as another mandolyn I have built.
If it is from a 1-wire sensor you can always exchange it to another one. If it is from PIR or DHT22 you can now change the sensorID in the EEPROM. Anyway, using fineoffset in stead of mandolyn is of no importance. If any, I'd say fineoffset is a little bit better now when there is a checksum validation at the telldus side.
free30 wrote:
All really good though, thanks again for this.
Wish I'd had the option of using your printed circuit board you have for sale on your site. All looks great.
![Smile :)](./images/smilies/icon_e_smile.gif)
PM me your address and I will see If I can solve it
EDIT: impossible to PM me since Telldus forum have not enabled that feature
![Smile :)](./images/smilies/icon_e_smile.gif)
. Go in to
http://foogadgets.tictail.com and contact me there.