Manage Dry Contact on CH54554 with Telldus Live [Solved]

[J78330]

Hello,

I am using the dry contact input to drive the motor of my garage door. I connected the dry contact input to the Chacon module CH54554. It runs, but I can not choose the good device in telldus live to send just a pulse.

I choosed the ON/OFF device and to drive my module, I must select On and after arround 1sec Off to put the contact down.

Do you know the solution to go back automaticly to status Off after a laps time in Telldus Live ?

Thanks in advance.

[trasa]

is the right module for your garage door?
You would need one that sends pulses.

This might work

http://www.intertechno.at/produkte/empf ... -1000.html

[J78330]

Yes, It looks like to the Chacon but you can setup the time to go back to the free potential. I didn't know this product (Thanks )

I will try to find it in France. (and/or try to find a solution by the software way !)