My forum

Just wondering will the TellStick work with any 433.92 device....?

Such as this one ? http://www.dealextreme.com/details.dx/sku.29570

No, not just any 433 MHz device. But a lot of them. We have to support them first before they will work.

I have not seen the one you refer to before so it will most likely not work with TellStick.

FYI - according to Telldus team (Telldus answers: 2011-02-08) the following socket receivers (SET OF 5 REMOTE CONTROL MAINS SOCKET SET by Mercury) are also NOT compatible with TellStick:
http://www.amazon.co.uk/SET-REMOTE-CONT ... roduct_top


It's too bad, because they were quite affordable--5x socket receivers for < £22 incl. S&H!

**UPDATE**
I was recently in touch with support from both Telldus and My Greener Home http://www.mygreenerhome.co.uk. They've confirmed that the ECOSAVERS remote self-learning socket receivers ARE NOT currently supported in the commercial TelldusCenter version. However, they've noted that these sockets are being implemented in the current dev build, which should be commercially released by Summer 2011. My Greener Home isn't bundling the ECOSAVERS with the TellStick anymore, but should be able to offer a substitute until full support for the ECOSAVERS comes in under TelldusCenter (in a few months?).

For anyone planning to purchase socket receivers that aren't explicitly supported by Telldus, I'd highly recommend double-checking with (the prompt & helpful) support teams first.

**Original post**

I just bought a TellStick + ECOSAVERS 3x self-learning remote socket receivers bundle: http://www.mygreenerhome.co.uk/standby- ... e-582.html


Are these ECOSAVERS actually compatible? I assume so, but TelldusCenter 2.0.4 (for OS X) doesn't have any relevant listing in the device setup list.

If these are compatible, please share which relevant device type I should use (and the associated protocol from tdtool & rfcmd [linux] CLI.)

NOTE - for the record, I went through the entire list manually trying to get the sockets to self-learn with TelldusCenter with these results (Remote code 1, unit code 1):
Bye Bye Standby = N/A
Chacon = no reaction
CoCo Technologies = no reaction
Conrad = light flashes as learned, but no reaction to switching
Elro = N/A
Goobay = N/A
GAO = no reaction
HomeEasy = no reaction
HQ = N/A
IKEA = N/A
Intertechno = no reaction
Kappa = no reaction
Kjell o Company = N/A
KlikAanKlikUit = no reaction
Nexa = no reaction
Otio = light flashes as learned, but no reaction to switching
Proove = no reaction
Rusta = N/A
Sartano = N/A
UPM = no learn button in TelldusCenter, and no reaction to switching
Waveman = N/A
X10 (experimental) = N/A

Thank you!

JD Moore