Raw codes from TelldusCenter?
Posted: Fri Mar 17, 2023 9:45 am
I would like to write some custom software for my home automation devices with the tellstick, but the problem I am having is that there is a big disconnect between the things I see in TelldusCenter and what is available in the APIs I see on the open source part of the web page. In TelldusCenter it took me just a few seconds to configure my specific devices and everything works. In the API however I have no idea what matches to what. It would be extremely helpful if TelldusCenter could give me the protocol names and also device codes of certain commands to ease development.
For example I have bought some devices which say "Everflourish" on the back. But in TelldusCenter they are listed under GAO. This is a bit confusing and took some googling to understand it's the same thing. Then I figured out that the code to calculate the actual commands can be found in this file: http://developer.telldus.se/browser/tru ... ourish.cpp. It would be helpful if TelldusCenter could output the codes it sends at least to the console so I can just copy paste them from there and directly use in my own software. Or alternatively I can check that the commands my code generates are the same as those TelldusCenter produces.
For example I have bought some devices which say "Everflourish" on the back. But in TelldusCenter they are listed under GAO. This is a bit confusing and took some googling to understand it's the same thing. Then I figured out that the code to calculate the actual commands can be found in this file: http://developer.telldus.se/browser/tru ... ourish.cpp. It would be helpful if TelldusCenter could output the codes it sends at least to the console so I can just copy paste them from there and directly use in my own software. Or alternatively I can check that the commands my code generates are the same as those TelldusCenter produces.