TellStick Duo On Raspberry Pi (WITHOUT TELLDUS CENTER)
Posted: Fri Mar 17, 2023 9:45 am
Hi everyone,
I'm a student and I'm currently working on Tellduc devices, the TellStick Duo.
I'm working both with the TelldusCenter, to "test" if it works, and then, with a application, in Java for the moment, which allows me to control the system. The "system" is composed of a TellStick Duo, a remote actuator and a temperature sensor, and the application allow me to set a temperature, and control the temperature of a room. If the real temperature is higher than the one set, the remote actuator will turn off. If it's not, it will turn on.
This application is currently working on my windows, but I have to carry it on a Raspberry Pi.
So I installed all the software for the TellStick Duo and tried it with the TelldusCenter, and it works !
But, when I want to use it on my application, I can't see any device..
My application is succesfully compiling and running, but I can't see devices. it might be caused by this :
The application is using the jstick library. I installed it and I think I did all what was needed, so I don't understand and I'm coming here to get some help..
I'm a student and I'm currently working on Tellduc devices, the TellStick Duo.
I'm working both with the TelldusCenter, to "test" if it works, and then, with a application, in Java for the moment, which allows me to control the system. The "system" is composed of a TellStick Duo, a remote actuator and a temperature sensor, and the application allow me to set a temperature, and control the temperature of a room. If the real temperature is higher than the one set, the remote actuator will turn off. If it's not, it will turn on.
This application is currently working on my windows, but I have to carry it on a Raspberry Pi.
So I installed all the software for the TellStick Duo and tried it with the TelldusCenter, and it works !
But, when I want to use it on my application, I can't see any device..
My application is succesfully compiling and running, but I can't see devices. it might be caused by this :
The application is using the jstick library. I installed it and I think I did all what was needed, so I don't understand and I'm coming here to get some help..