Page 1 of 1
Adding hardware constructed by me?
Posted: Fri Mar 17, 2023 9:45 am
by lukaszrzepinski
Hi!
I have been developing things and own hardware with my own cloud or OpenHab software.
My very basic question here (because I am considering if it is possible to build HW compatible with TellStick) : is TS open so that I can add my HW?
I understand that it uses proprietary 433MHz protocol?
Thank you in advance
Lukas
Re: Adding hardware constructed by me?
Posted: Fri Mar 17, 2023 9:45 am
by etompau
What kind of HW have you built? Is it receiving or transmitting equipment?
Perhaps you should take a look at Telldus developer site:
http://developer.telldus.com/wiki
Re: Adding hardware constructed by me?
Posted: Fri Mar 17, 2023 9:45 am
by lukaszrzepinski
hi
it is basically set of sensors, temperature, humidity, ground humidity, rain sensor, window open sensor - they are wifi based (ESP8266 wifi card) and so far I was connecting them to OpenHab.
Now I am thinking to do something similiar with Telldus but it seems that Telldus supports only Z-wave and 433Mhz for HW. Are those protocols open? I see in shops that some devices like sockets and sensors appeared with "Tellstick commpatible" stamp
Re: Adding hardware constructed by me?
Posted: Fri Mar 17, 2023 9:45 am
by lukaszrzepinski
Update, here is the project of self-made temperature sensor compatible with Tellstick Duo (over 433Mhz)
https://forum.arduino.cc/index.php?topic=211371.0