My forum

Hi,

I have a just-another-led-christmas-lights behind Nexa PE-3 and on/off works just fine, but if I switch Nexa PE-3 off, lights go off, but they blink every 3-4 seconds. Anyone else noticed similar behavior? Seems like the switch is 'leaking' enough electric for led lights to blink.

Tried also with another Nexa PE-3 switch and same thing, so it is not question of malfunction of Nex PE-3.

The LED blinking is caused by the small current induced in wires on the printed board of the Nexa receiver.
Try to increase the load, by connecting a small lamp in parallel and the phenomena should disappear.