My forum

Hi all‚ i've just installed one x10 AD11 in my home and i'm surprise it doesn't work. Someone have this device too?
I've test the x10 on differents code ans no way to turn on or off ...

It's m'y first X10 device ...
The link of product : http://www.domadoo.fr/fr/peripheriques/ ... 03237.html

I think this device use the power line for communication...so you would also need a controller that translates the radio frequency commands from Tellstick to power line messages. Like the TM13

It's true !

Thx krambriw, I will try to return the product to the seller and I will buy an other instead...

I'm working on Jeedom to control the Tellstick net (433mhz), in more of my Razberry(z-wave), so I will buy the z-wave device : FGS-211

If you are into Jeedom, you have to check also Node-RED (there is a node available to integrate Jeedom with Node-RED)

I also have the Razberry z-wave, it is working fine, reliable and you get status feedback

krambriw wrote:If you are into Jeedom, you have to check also Node-RED (there is a node available to integrate Jeedom with Node-RED)

I also have the Razberry z-wave, it is working fine, reliable and you get status feedback

Node-RED is for the tellstick in USB, not for tellstick net, right ?

Node-RED is for the tellstick in USB, not for tellstick net, right ?

Correct, yes, it is supporting Duo and Classic, not for Net

...but if Jeedom is supporting Net, you can connect Jeedom with Node-RED and then use the rest of the wonderful collection available for Node-RED