My forum

In my garage I have my normal transmitters bought from the company that supplied the garage-door and opener, but just inside the door I put in a simple door-bell switch where I just press once to close, once again to stop it, and then so on. Just simple press and release button. I was wondering if Nexa or Proove or any other easy to find vendor has any wireless controlled buttons I can replace that one with, where I have the wires going to the garage-door opener, and in addition I can use my Tellstick Net to communicate directly with it if I want to open/close through my phone or any other online thing?

Anyone have one to recommend? Remember it needs to be a combo of both wired (low voltage) and wireless receiver. I guess I can mount a second receiver in parallel to the normal one I have there now, but for aesthetic reasons it would be nice to combine the functions into one

None that have any idea what to use here? Any other suggestions on how to solve this?

Tom_B wrote:None that have any idea what to use here? Any other suggestions on how to solve this?

Intertechno itl - 1000 relay on the key wires on your garageopener with a wireless transmitter on the wall. You can then control your garage door with mobile and wall button.

reidar.ostrem wrote:

Tom_B wrote:None that have any idea what to use here? Any other suggestions on how to solve this?

Intertechno itl - 1000 relay on the key wires on your garageopener with a wireless transmitter on the wall. You can then control your garage door with mobile and wall button.

[attachment=-1]uploadfromtaptalk1413300440574.jpg[/attachment]

From your description, I would say that you need a receiver with a potential free contact. Then perhaps you could try the Nexa WRR-1 from their Pro-serie. (don't know if it's available in your country). This receiver has a dry contact that you could connect in parallel with existing button. The receiver has also inputs for an external switch.
Another solution could be to re-build a LCMR-1000. This receiver can easily (soldering on the PCB) be re-worked for low voltage use (12 Vac) and potential free contacts.

I have ordered a couple of the below, took a couple of weeks to get them but they are cheap and working fine. You also need a 12V power supply (PS specify the 433MHz version)

http://www.aliexpress.com/store/product ... 34863.html

If you go for the Intertechno relay they sell them at Bauhaus I think but I ordered it from eBay.

This new reciever from nexa has potential free contact:
http://www.nexa.se/EJLR-1000.htm