I use wireless Multisensor for my exsisting 1 wire net, but now I will go further ...
What is the trick for having a 1 wire net connected directly to the Pi and Automagically? In the System Settings for Automagically, you can enable this feature. Do I have to use a serial interface in USB port or should it be connected to the GPIO pins?
Is there any schematic "out there" for my purpose? Parasitic or non parasitic? Ok, i know there are schematics for 1 wire nets, but I can't find anything in combination with Automagically.
/misterleffe
1 Wire for Pi
Re: 1 Wire for Pi
You can use any hardware to connect to your 1-wire for instance 1-wire board connected to GPIO or usb 1-wire board. Then you have to run owserver which is not in the scope for automagically. Automagically just connects to owserver reglardless of how the 1-wire net is connected.
Re: 1 Wire for Pi
Någon som testat dessa med Automagically?
https://www.m.nu/rpi-i2c-1wire-expansio ... p-677.html
http://wiki.temperatur.nu/index.php/OWFS_on_Rasperry_Pi
/Marcus
https://www.m.nu/rpi-i2c-1wire-expansio ... p-677.html
http://wiki.temperatur.nu/index.php/OWFS_on_Rasperry_Pi
/Marcus
Re: 1 Wire for Pi
Jag kör något liknande kort, men som sagt automagically bryr sig inte om hårdvaran, det viktiga är att owserver kan kommunicera med hårdvaran.KHolm wrote:Någon som testat dessa med Automagically?
https://www.m.nu/rpi-i2c-1wire-expansio ... p-677.html
http://wiki.temperatur.nu/index.php/OWFS_on_Rasperry_Pi
/Marcus
Automagically kommunicerar bara med owserver.
-
- Posts: 57
- Joined: Fri Mar 17, 2023 9:45 am
Re: 1 Wire for Pi
Är det "bara" att följa Wiki'n och installera 1-wire-expansion-module på GPIO pinnarna och sen är det bara att "tuta & köra"? Som jag ser det i Wiki'n kan man även köra med USB adapter?sova wrote:Jag kör något liknande kort, men som sagt automagically bryr sig inte om hårdvaran, det viktiga är att owserver kan kommunicera med hårdvaran.KHolm wrote:Någon som testat dessa med Automagically?
https://www.m.nu/rpi-i2c-1wire-expansio ... p-677.html
http://wiki.temperatur.nu/index.php/OWFS_on_Rasperry_Pi
/Marcus
Automagically kommunicerar bara med owserver.
Om jag då sen aktiverar 1-wire i Automagically's "System Settings", kommer då det att trilla in mätvärden?
/misterleffe