My forum

Hi!

I bought three temperatur sensors at Clas Ohlson (http://www.clasohlson.com/no/Ekstra-tem ... r361797000). They should appear as "mandolyn temperaturehumidity " when doing a tdtool -l. The problem is that only one device is showing. And it seems like it collecting data from all the devices, becase the temperature is changing. But I can only see one device.

Can all the devices have the same ID? Any suggestions?

SENSORS:

PROTOCOL MODEL ID TEMP HUMIDITY LAST UPDATED
mandolyn temperaturehumidity 11 22.7° 52% 2013-02-07 22:03:43

It is very likely like you say. All sensors have by default the id 11 (House Code=1 and Channel Code=1 ) if you do not change it.
In the battery case you find two buttons, "Set" and "C/F". Press "Set" and then "C/F" and watch what is happening on the display.

Great! Thanks! It worked.

SENSORS:

PROTOCOL MODEL ID TEMP HUMIDITY LAST UPDATED
mandolyn temperaturehumidity 11 7.8° 62% 2013-02-08 14:09:26
mandolyn temperaturehumidity 13 20.0° 56% 2013-02-08 13:39:41
mandolyn temperaturehumidity 12 23.3° 63% 2013-02-08 13:37:41

But it's only the sensor with ID 11 that updates. Can I somehow change the interval, or trigger new data from the sensors?