Support of uniTEC EIM-826 power switches
Posted: Fri Mar 17, 2023 9:45 am
I recently bought a set of uniTEC power switches at a local DIY (Bauhaus).
So far I wasn't able to control those via the TellStick.
They are pre-programmed, i.e. I couldn't find and changeable codes etc.
There is only a sticker with the number 1, 2 or 3 attached to the devices.
Does anyone know, if these device are or will be supported in future?
Thanks & regards,
Dirk
So far I wasn't able to control those via the TellStick.
They are pre-programmed, i.e. I couldn't find and changeable codes etc.
There is only a sticker with the number 1, 2 or 3 attached to the devices.
Does anyone know, if these device are or will be supported in future?
Thanks & regards,
Dirk