My forum

Hello,
I have just purchased a Tellstick Net. Is it possible to use my Conrad RSL blind actuator with the Tellstick? I have tried the blind / screen settings in Telldus Live. But they didn't work.
In the previous post someone said the conrad 433 Mhz RSL Product is supported.

Is it possible to find out the right codes on my own (Like sniffing the traffic between remote control an actuator)?

Here is the Link to the product:

Link to Conrad blind actuator RSL

Greetings

Piet

Have you tried configure it as a Conrad device?

Tonight I was able to test the Conrad RSL blind actuator with the settings for the conrad switching device in Telldus Live.
It works !!
Switching off in Telldus Live and the blind goes down.
Switching on in Telldus Live and the blind goes up.

Maybe you could register this device in your Telldus Live Application as a blind so that the comfortable "up", "down" and "stop" buttons appear.

Thanks for your help.

Greetings Piet

jp_fahs wrote:Tonight I was able to test the Conrad RSL blind actuator with the settings for the conrad switching device in Telldus Live.
...

Maybe you could register this device in your Telldus Live Application as a blind so that the comfortable "up", "down" and "stop" buttons appear.

Thanks for your help.

Greetings Piet

It should also be good if the x10 system should became the posibility to stop the device. There is at the time also only the posibility to have the jalossi up or comlitly closed.
I have this device marmitek SW10 http://www.marmitek.com/de/produkt-deta ... e/sw10.php
It should be great to updateTelldus Live with this fearture or set it on the roadmap.