My forum

Hi,

I'm using the remotes (OTIO) what I have buy with devices and telldus live in parallel and I need to register all devices in all remotes and it's bad ...
And I don't have the current status of devices in live because if I use one remote the live is not updated ...

So a good idea, I don't register one device in remote, but I send a command to the telldus, who show actions on devices

I offers :
- A page with list of signals registered


- The same page with form to add a signal


- And the page who can add actions when signal is detected




For information I'm working on the map of my home (all in html5) and I will control all with this :

and also the possibility to show actions if sensor is > or < to temperature wanted

Hi
Nice work !
I have tellstick net V3 but I don't have >My Remote button on my Telldus Live!
Where are you found this function ?

regards

I like the idea very much!

Hi
it would be king that this project is successful and can be integrated on telldus Live!.
I support manticus and developers' to complete this project.

regards

link :
http://developer.telldus.com/ticket/87
Possible to act on a received signal. New type of "receiving device" which can be connected, via a method (e.g. on/off/dim), to another device or device group.

Manticus2 wrote:For information I'm working on the map of my home (all in html5) and I will control all with this :

Hi,

this is way off topic but I couldn't help noticing in the attached picture that you as well have these weird temperature readings (-204,7C). What's the story with these, any idea? I have a few of those under my sensors. I've thought they have something to do with my wireless thermometers (although I have not tried to add any) but if tellstick live is clever enough to find them automatically then why a nonsense temperature reading... Or are these coming from somewhere else:

Ok, found ticket #243 and I guess it will be taken care of in near future...
http://developer.telldus.com/ticket/243