My forum

Hello @ all

I have a Homeeasy HE304-Switch and i dont know how it works with telldus Center. I have a Tellstick (old design). I use TelldusCenter 2.1.0a
What a make:
1. I install the software.
2. I test the software mit many other receivers like (Sartano) and it works perfect.
3. now i plug in the the HE-304 with a lamp
4. when i reset the HE-304 (6 seconds push on the learningbutton) the the lamp flash short on and off.
5. Now i open tellduscenter go to homeeasy - to self learning on/off (i see a picture of my HE-304 - the left one)
6. Now i press randomize and become a code of up 5 digits. I leave the unitcode on 1 and klick on save.
7. Now i press the HE-304 learning-button for 3 seconds and the light is flashes.
8. I press the On button in TelldusCenter and nothing happens.

What make i wrong

on the bakeside of my receiver from homeeasy are the following informations:
Type: HE304BEU
230-240V - 50Hz
max. 1000W
Resistive load
Frequency 433.92Mhz
R&TTE approved
Made in China
Lot Number 12A09

HomeEasy EU is unfortunately not supported. They differ from the UK model in their communication.

is it plan in future, to support the EU-Versions or is it compatible. It looks like intertechno.

They are not compatible with Intertechno. The protocol differs.

To be able to support them someone need to figure out how they communicate.