Voltcraft (especially Cost Control Center 3000) support
Posted: Fri Mar 17, 2023 9:45 am
Hi there,
first post ;9.. so I just bought the Voltcraft Cost Control Center 300 (http://www.produktinfo.conrad.com/daten ... 00_SET.pdf).
It contains 4 wireless switches and a cost control device. So as you might guess I was trieing to get it working with remotestick.
So first Problem I dont't know if there is a Protocoll implemented supporting this device. Is there a way to detect this?
Second, I tried to b clever
The switches have a learning-button. So I thought maybe they are using the "arctech"-protocol. But I tried it with self-learning switch. Switched the Device on.... nothin happended 
. So I thought maybe the device only accepts a limited range of values in the house parameter. Is there a way to detect that??
Or is there any other way to get this running? Probably a way to let the switch listen to the commands sent by the remote...
Thanks for your answers!!
greetz myname
first post ;9.. so I just bought the Voltcraft Cost Control Center 300 (http://www.produktinfo.conrad.com/daten ... 00_SET.pdf).
It contains 4 wireless switches and a cost control device. So as you might guess I was trieing to get it working with remotestick.
So first Problem I dont't know if there is a Protocoll implemented supporting this device. Is there a way to detect this?
Second, I tried to b clever
The switches have a learning-button. So I thought maybe they are using the "arctech"-protocol. But I tried it with self-learning switch. Switched the Device on.... nothin happended . So I thought maybe the device only accepts a limited range of values in the house parameter. Is there a way to detect that??Or is there any other way to get this running? Probably a way to let the switch listen to the commands sent by the remote...
Thanks for your answers!!
greetz myname