Hi there,
first post ;9.. so I just bought the Voltcraft Cost Control Center 300 (http://www.produktinfo.conrad.com/daten ... 00_SET.pdf).
It contains 4 wireless switches and a cost control device. So as you might guess I was trieing to get it working with remotestick.
So first Problem I dont't know if there is a Protocoll implemented supporting this device. Is there a way to detect this?
Second, I tried to b clever The switches have a learning-button. So I thought maybe they are using the "arctech"-protocol. But I tried it with self-learning switch. Switched the Device on.... nothin happended . So I thought maybe the device only accepts a limited range of values in the house parameter. Is there a way to detect that??
Or is there any other way to get this running? Probably a way to let the switch listen to the commands sent by the remote...
Thanks for your answers!!
greetz myname
Voltcraft (especially Cost Control Center 3000) support
Moderator: Telldus
-
- Posts: 2
- Joined: Fri Mar 17, 2023 9:45 am
-
- Site Admin
- Posts: 2243
- Joined: Fri Mar 17, 2023 9:45 am
- Location: Lund
- Contact:
Re: Voltcraft (especially Cost Control Center 3000) support
Try to configure them as a "UPM" device.
Micke Prag
Software
Telldus Technologies
Software
Telldus Technologies
-
- Posts: 2
- Joined: Fri Mar 17, 2023 9:45 am
Re: Voltcraft (especially Cost Control Center 3000) support
You're a fucking genius That works. So if someone wants to update the compatibilies. The switches metioned above are working with TellStick upm.micke.prag wrote:Try to configure them as a "UPM" device.
greeetz and very much thanks!!
myname