Hi, I have the fibaro smart implant (FGBS-222). This is a universal z-wave device. My intention is to use it to monitor my well pump, and make sure it is not on for long periods. It should have 2 binary sensor inputs, 1 serial "1-wire" sensor input, and 2 outputs. I intend to use one of the binary sensors to detect if a switch (pump pressure switch) is open or closed.
(here is the manual: https://manuals.fibaro.com/smart-implant/)
I have successfully paired it with the Tellstick Znet Lite v2, however it is seen apparently as 8 switch devices and one sensor. I expected to find atleast 2 sensors. I tried adjusting the configuration parameters, in particular the input configuration parameters 20 and 21, but not much joy there.
Any advice or experience on how I might configure this with telldus live?
Thanks
Fibaro Implant
Moderator: Telldus
Re: Fibaro Implant
I'm experience the same problem as you do.
I've not been able to change parameters 20 and 21. How did you manage that?
I've not been able to change parameters 20 and 21. How did you manage that?