Hi,
Is there any way to control the projection screen from Euroscreen with a tellstick (net)?
I have RF HEX codes for the Global Cache iTach, are those of any use to me, should I go for another solution?
Is there any support for running theses hex codes directly using tellstick?
/R
Euroscreen RF control
Moderator: Telldus
-
tahustvedt
- Posts: 2
- Joined: Fri Mar 17, 2023 9:45 am
Re: Euroscreen RF control
Hi.
I know this is an old thread, but I have a solution that may help others. The RF remote for my screen didn't work against the Tellstick either. I have a Dreamscreen Tab V3 (I think).
My screen has a 12v in trigger (which most screens have) and the projector has a 12v out. I used a small 12v adapter connected to the screen input, which was activated by a Proove remote switch. That works fine.
I also modified a window sensor by replacing the reed switch insite and soldering a relay across the pads on the PCB, which was really easy to do. The 12v out from the projector as it powers up triggers the window sensor. Then I used an event to control the screen when the "window sensor" was triggered by the projector. I also triggered the lights to dim and turn off at the same time.
I know this is an old thread, but I have a solution that may help others. The RF remote for my screen didn't work against the Tellstick either. I have a Dreamscreen Tab V3 (I think).
My screen has a 12v in trigger (which most screens have) and the projector has a 12v out. I used a small 12v adapter connected to the screen input, which was activated by a Proove remote switch. That works fine.
I also modified a window sensor by replacing the reed switch insite and soldering a relay across the pads on the PCB, which was really easy to do. The 12v out from the projector as it powers up triggers the window sensor. Then I used an event to control the screen when the "window sensor" was triggered by the projector. I also triggered the lights to dim and turn off at the same time.