Har under ett drygt ett halvår kört Tellstick & HomeAutomation 1.1 i min Debian-server. Häromdan började det krångla, med detta meddelande i dmesg när man kopplar i Telllsticken:
Code: Select all
ftdi_sio ttyUSB0: ftdi_set_termios FAILED to set databits/stopbits/parity
ftdi_sio ttyUSB0: ftdi_set_termios urb failed to set baudrate
ftdi_sio ttyUSB0: urb failed to clear flow control
ftdi_sio ttyUSB0: Unable to write latency timer: -71
ftdi_sio ttyUSB0: ftdi_set_termios FAILED to set databits/stopbits/parity
ftdi_sio ttyUSB0: ftdi_set_termios urb failed to set baudrate
ftdi_sio ttyUSB0: urb failed to clear flow control
ftdi_sio ttyUSB0: ftdi_set_termios FAILED to set databits/stopbits/parity
ftdi_sio ttyUSB0: ftdi_set_termios urb failed to set baudrate
ftdi_sio ttyUSB0: urb failed to clear flow control
usb 1-1.1: USB disconnect, address 3
ftdi_sio ttyUSB0: FTDI USB Serial Device converter now disconnected from ttyUSB0
ftdi_sio 1-1.1:1.0: device disconnected
hub 1-1:1.0: Cannot enable port 1. Maybe the USB cable is bad?
hub 1-1:1.0: Cannot enable port 1. Maybe the USB cable is bad?
hub 1-1:1.0: Cannot enable port 1. Maybe the USB cable is bad?
hub 1-1:1.0: Cannot enable port 1. Maybe the USB cable is bad?
hub 1-1:1.0: unable to enumerate USB device on port 1
hub 1-1:1.0: Cannot enable port 1. Maybe the USB cable is bad?
hub 1-1:1.0: Cannot enable port 1. Maybe the USB cable is bad?
hub 1-1:1.0: Cannot enable port 1. Maybe the USB cable is bad?
hub 1-1:1.0: Cannot enable port 1. Maybe the USB cable is bad?
hub 1-1:1.0: unable to enumerate USB device on port 1
Jag har inte rört Tellsticken under detta halvår, är det någon som har tips om hur jag får fason på det hela??