Fibaro Implant

Moderator: Telldus

Post Reply
Posts: 3
Joined: Tue May 07, 2019 7:12 pm

Fibaro Implant

Post by jeremyc » Tue May 14, 2019 7:59 am

Hi, I have the fibaro smart implant (FGBS-222). This is a universal z-wave device. My intention is to use it to monitor my well pump, and make sure it is not on for long periods. It should have 2 binary sensor inputs, 1 serial "1-wire" sensor input, and 2 outputs. I intend to use one of the binary sensors to detect if a switch (pump pressure switch) is open or closed.

(here is the manual:

I have successfully paired it with the Tellstick Znet Lite v2, however it is seen apparently as 8 switch devices and one sensor. I expected to find atleast 2 sensors. I tried adjusting the configuration parameters, in particular the input configuration parameters 20 and 21, but not much joy there.

Any advice or experience on how I might configure this with telldus live?


Posts: 4
Joined: Thu Jan 18, 2018 11:08 am

Re: Fibaro Implant

Post by Fallber » Sun May 26, 2019 7:59 am

I'm experience the same problem as you do.
I've not been able to change parameters 20 and 21. How did you manage that?

Post Reply