Page 1 of 1

1 Wire for Pi

Posted: Fri Mar 17, 2023 9:45 am
by misterleffe
I use wireless Multisensor for my exsisting 1 wire net, but now I will go further ...

What is the trick for having a 1 wire net connected directly to the Pi and Automagically? In the System Settings for Automagically, you can enable this feature. Do I have to use a serial interface in USB port or should it be connected to the GPIO pins?

Is there any schematic "out there" for my purpose? Parasitic or non parasitic? Ok, i know there are schematics for 1 wire nets, but I can't find anything in combination with Automagically.



/misterleffe

Re: 1 Wire for Pi

Posted: Fri Mar 17, 2023 9:45 am
by sova
You can use any hardware to connect to your 1-wire for instance 1-wire board connected to GPIO or usb 1-wire board. Then you have to run owserver which is not in the scope for automagically. Automagically just connects to owserver reglardless of how the 1-wire net is connected.

Re: 1 Wire for Pi

Posted: Fri Mar 17, 2023 9:45 am
by KHolm

Re: 1 Wire for Pi

Posted: Fri Mar 17, 2023 9:45 am
by sova
Jag kör något liknande kort, men som sagt automagically bryr sig inte om hårdvaran, det viktiga är att owserver kan kommunicera med hårdvaran.
Automagically kommunicerar bara med owserver.

Re: 1 Wire for Pi

Posted: Fri Mar 17, 2023 9:45 am
by misterleffe
sova wrote:
Jag kör något liknande kort, men som sagt automagically bryr sig inte om hårdvaran, det viktiga är att owserver kan kommunicera med hårdvaran.
Automagically kommunicerar bara med owserver.
Är det "bara" att följa Wiki'n och installera 1-wire-expansion-module på GPIO pinnarna och sen är det bara att "tuta & köra"? Som jag ser det i Wiki'n kan man även köra med USB adapter?

Om jag då sen aktiverar 1-wire i Automagically's "System Settings", kommer då det att trilla in mätvärden?


/misterleffe