I'm running Home assistant, Hassio on a Raspberry Pi 3 for use with my Telldus Live account and have also installed Node Red in Hassio for a better overview of the automation programming.
Have managed to get my wall socket switches to appear in Node Red and can control them in a Flow with a simple Inject node connected to a wall socket switch.
Now to my problem.
I also have a PIR sensor from Telldus that appears in Node Red but I cannot use it and it is not possible to read any status from it. It works fine inside Telldus Live and there i can see how it changes state.
I intend to use this to light up the stairs at night so I would also appreciate any tip how such a flow would look like. After PIR-triggering the light should be lit for 5 minutes and then turn off.
Would be glad for any help, I am new to Hass.io and Node Red.
1 post • Page 1 of 1