Tellstick Duo doesn't process raw commands

Moderator: Telldus

Post Reply
zephyrin
Posts: 1
Joined: Fri Mar 17, 2023 9:45 am

Tellstick Duo doesn't process raw commands

Post by zephyrin »

Hi,

I tried to control a device from command line:

Code: Select all

D:\>echo 'S a a a a a a a a a a a a aa  aa  aa  aa  a a aa  +' | "c:\Program Files\Telldus\tdtool.exe" --raw -
Sending raw command: Success
This works fine with Tellstick (Firmware 6), but not with Tellstick Duo (Batch #13062, FW 5 and 12).
Both Sticks report success immediately, but there is no red LED blinking on Duo Stick.
(blinking was observed with another device and tdtool.exe --on 2, which works on both sticks).

The sticks are not inserted at the same time.

Using TelldusCenter 2.1.2 Beta 10 (but was the same problem with Version 2.1.1)

All suggestions are welcome and appreciated.

Best Regards,
Zephyrin
Post Reply