Tellstick Duo doesn't process raw commands

Moderator: Telldus

Post Reply
zephyrin
Posts: 1
Joined: Thu Jan 18, 2018 11:08 am

Tellstick Duo doesn't process raw commands

Post by zephyrin » Thu Jan 18, 2018 11:08 am

Hi,

I tried to control a device from command line:

Code: Select all

D:\>echo 'S a a a a a a a a a a a a aa  aa  aa  aa  a a aa  +' | "c:\Program Files\Telldus\tdtool.exe" --raw -
Sending raw command: Success
This works fine with Tellstick (Firmware 6), but not with Tellstick Duo (Batch #13062, FW 5 and 12).
Both Sticks report success immediately, but there is no red LED blinking on Duo Stick.
(blinking was observed with another device and tdtool.exe --on 2, which works on both sticks).

The sticks are not inserted at the same time.

Using TelldusCenter 2.1.2 Beta 10 (but was the same problem with Version 2.1.1)

All suggestions are welcome and appreciated.

Best Regards,
Zephyrin

Post Reply