My forum

I have a Nexa Mycr-100 plug dimmer. The only way to adjust the lower dimmer level is, according to the manual and nexa support, to use a system nexa remote and press ON button for three seconds. It doesn't work with the ANSLUT remotes I own.

Does anyone have any idea what the remote sends and if it could be generated with Tellstick Net/Znet or another remote somehow?

The remote control only sends a repeated stream of ON-commands when the button is pressed, no special commands etc.
Have you considered the fact that the remote used for adjusting the low light level, previously must have been paired with the dimmer?

Thanks. Yes, it's paired and works to turn on and off with. I tried both to hold the ON button and to press it many times quickly, without success. But knowing now that there is no magic signal from a Nexa remote, I'll try a bit more.