Page 1 of 1


Posted: Sun Oct 14, 2018 9:38 am
by johndehosson
Hi guys!

Seriously struggling with understanding how to get the wall mounted Z-Wave controller ZME-WallC-S working.

Can anyone please help with some step by step tips?

Looking forward to hearing from you.


Re: ZME-WallC-S

Posted: Sun Oct 14, 2018 8:15 pm
by arneolav
Bring your Z-Wave controller (Telldus zNet..) in the inclusion/exclusion mode:

On Telldus Live web page, on page CONTROL DEVICES:
Select add new device wizard (click on + sign in upper right corner)
Select your Telldus zNet
Select zwave

Whitin some seconds (at least less than a minute):

On the ZME, press one of the buttons on the unit for more than one second.
The two LEDs begin to flash rapidly.
The device should be included automatically after 10 seconds.

Configuration parameter 11-14 needs to be set in order to get this remote control to work properly.
Paddel 2 can not be used to trigger events, it can only be used when associated with other Z-Wave products.

More info at: ... allc-s.pdf