My forum

Hi, I have a setup where a Intertechno motion detector should communicate via Tellstick (Duo) with my home automation application which should then turn on a lamp (also Intertechno). The setting works fine except that it needs 2-3 seconds for the lamp to turn on. This is a not acceptable, uncomforta...

Do you think I can simultaneously send via a second Tellstick with a different house code w/o disrupting anything? Or would I be required to switch to 833Mhz motion detector sensors instead?

I think I get the point. In order to prevent the motion sensor to power off the lamp I would then need two switches in parallel for the lamp, one triggered directly and immediately by the motion sensor, the other parallel triggered with the mentioned delay by the tellstick. This seems to be the only...

I originally wanted to decouple the motion sensor and the lamp to d advanced calculations in my raspberry. But roughly I want the following: The specification is: - 1x tellstick, 1x lamp, 1x motion sensor, 1x manual switch 1. when entering the room as detected by the motion sensor, turn lamp on 2. w...