Can anyone show an example of a raw command for a Nexa selflearning dimmer?
I found an example for code switch:
4:sendh1:S32:$k$k$k$k$k$k$k$k$k$k$k$k$k$k$k$k$k$k$kk$$kk$$k$k$ks
Nexa Arctech selflearning raw example
Moderator: Telldus
Re: Nexa Arctech selflearning raw example
*Bump*
Is it possible to use this raw commands to send Nexa self learning protocol?
Maybe some of the developers can ansver this?
An example would also been nice
Is it possible to use this raw commands to send Nexa self learning protocol?
Maybe some of the developers can ansver this?
An example would also been nice
Re: Nexa Arctech selflearning raw example
bump bump
Is there any devs here, or is this project dead?
Is there any devs here, or is this project dead?
Re: Nexa Arctech selflearning raw example
Hi,
I'm looking for the same thing - please have a look at this post by me:
https://www.telldus.com/forum/viewtopic.php?f=11&t=5937
It also contains a Python implementation of a Raw string generator for Nexa Selflearning switches. (The issue is however that I can't get it work, but perhaps it can serve as a next step on this question.)
Regards,
Roger
I'm looking for the same thing - please have a look at this post by me:
https://www.telldus.com/forum/viewtopic.php?f=11&t=5937
It also contains a Python implementation of a Raw string generator for Nexa Selflearning switches. (The issue is however that I can't get it work, but perhaps it can serve as a next step on this question.)
Regards,
Roger