SARTANO protocol & device

[danardf]

Hi.

I don't know if the name and the protocol are right .

Code: Select all

deviceNode = "/dev/ttyUSB0"
device {
  id = 1
  name = "Salon"
  protocol = "SARTANO"
  model = "SARTANO"
  parameters {
  code = "1000010000"
  }
}

And what's the connection with the code?
"12345ABCDE", "ABCDE12345", "EDCBA54321" ...Etc

Regards

[micke.prag]

Since the receiver has a dip-switch, it can only be ones and zeroes...

[danardf]

Ok so 12345ABCDE

Hmmm I've only one or two device that works.

My receivers are at 5m or 6m from the tellstick, and between, there's a wall.
With the telecommand, no problem.

I had a doubt for the code, but no, it's right.

I'll try to make some test with a USB wire.
The best would be the possibility to put an external antenna.

Regards

[micke.prag]

If you want an external antenna. Send us an email to rma at telldus dot se with your batch number, place of purchase and your address.

[danardf]

Why not but I don't know if it's possible to have an antenna for this device.
There's no connector to put it. At least of to change the device.

[danardf]

I make some test (Linux and Windows), and as you said about the range : Up to 30 meters, it's not really that.
The range is less large than the telecommand which have a real range of 30m.
With your device, I've only 4m max with 1 wall (0.80m). When I take my telecommand, the signal is good and the receiver works perfectly. With 4m, I can put a wire and a relay for the same result.
At least that the device have a default.
Otherwise, I wonder if this device is useful for me.

What do you think about that?

Regards

Franck

[micke.prag]

Read my earlier post. "Send us an email to rma at telldus dot se with your batch number, place of purchase and your address." and we will exchange your TellStick with one with an external antenna.

[danardf]

Good.
It's cool.
I hope that will be right.

Thanks

Regards