TellStick Net and signals from wall switchs

jnsfi · Post by **jnsfi** » Fri Mar 17, 2023 9:45 am

Hi!

Can TellStick Net recognize a signal from the wall switch (Nexa WST-512) and then send a signal to the receiver (Nexa ECMR-250)?
My scenario: I press wall switch -> Tellstick Net recogizes it and sends command/commands to receiver/receivers.

This kind of linkage would be really nice - then Telldus Live would know if lamp are turned off with wall switch.

rhoddas · Post by **rhoddas** » Fri Mar 17, 2023 9:45 am

jnsfi wrote:Hi!

Can TellStick Net recognize a signal from the wall switch (Nexa WST-512) and then send a signal to the receiver (Nexa ECMR-250)?
My scenario: I press wall switch -> Tellstick Net recogizes it and sends command/commands to receiver/receivers.

This kind of linkage would be really nice - then Telldus Live would know if lamp are turned off with wall switch.

Yes

jnsfi · Post by **jnsfi** » Fri Mar 17, 2023 9:45 am

How?

Dowser · Post by **Dowser** » Fri Mar 17, 2023 9:45 am

Possibly by using custom firmware. It's not supported by Live.

rhoddas · Post by **rhoddas** » Fri Mar 17, 2023 9:45 am

jnsfi wrote:How?

Oops - I didn't see that it was a Tellstick Net you asked about. In that case it much trickier I think

jnsfi · Post by **jnsfi** » Fri Mar 17, 2023 9:45 am

OK. This would be a really nice feature to Live.

grrrmml · Post by **grrrmml** » Fri Mar 17, 2023 9:45 am

Hi,
I just want to put this back to focus, because I'm wondering if it was possible to control an intertechno self-learning switch with BOTH hardware-remote (non-code-switch) AND Tellstick Net (in my case via RemoteStick) in parallel.
That means either finding the (generated randomly once?) code of the remote or have tellstick forward such to known self-learning switches. Does anybody have knowledge about it?
Kind regards, grrrmml

jorang · Post by **jorang** » Fri Mar 17, 2023 9:45 am

Can comfirm that Intertechno ITL-500 and ITL-1000 functions with Net/ Live!

My forum