Aeonlabs Multisensor gen 5 + Telldus Znet v2

Moderator: Telldus

Post Reply
Mattias_jo1
Posts: 20
Joined: Thu Jan 18, 2018 11:08 am

Aeonlabs Multisensor gen 5 + Telldus Znet v2

Post by Mattias_jo1 » Thu Jan 18, 2018 11:08 am

Hej,

Har nyligen lagt till en Aeonlab Multisensor gen5 i min Telldus Znet v2.

Kör den med ström (dvs ej batteri). Jag får mätvärden från Temp och luminance men ej fukt. Får inte rörelse sensorn att trigga rörelse.
trots "enabled" under inställningar.

Tips mottages.

Edit: Lagt till param 5 och 42. Nu funkar rapportering av fukt men inte rörelse.

Mvh
Mattias

1: Sensor report type on get without instances?
Temperature


2: Wake up 10 minutes when batteries are inserted?
No

No
Yes

3: On time? 1seconds
Slider thumb shadowSlider thumb

delay

4: Motion sensor?
Enabled


101: Send unsolicited reports periodicaly. interval group 1? Battery report
Temperature
Humidity
Luminosity

102: Send unsolicited reports periodicaly. interval group 2? Battery report
Luminosity
Temperature
Humidity

103: Send unsolicited reports periodicaly. interval group 3? Battery report
Temperature
Humidity
Luminosity

111: Unsolicitate reports interval for timing groups 1? 1seconds
Slider thumb shadowSlider thumb


112: Unsolicitate reports interval for timing groups 2? 1seconds
Slider thumb shadowSlider thumb


113: Unsolicitate reports interval for timing groups 3? 1seconds
Slider thumb shadowSlider thumb


Sometimes a device can have extra configuration that we can't detect automatically, if there are some listed in the device manual, you can enter them here.
Number
0
Size
Value
0

Add

Post Reply