http://nexahome.se/rpi/2016-03-18-jessi ... -eng-v1.7z (engelsk)
Jag ser att det finns ett menyalternativ för 'Activate Telldus Live' i TelldusCenter, någon kanske kan testa
Se även "Tips: NexaHome - Raspbian wheezy - TellStick - RaZberry"
http://www.telldus.com/forum/viewtopic.php?f=23&t=3157
readme.txt
Code: Select all
******************************************************************************************************
NexaHome, TellStick/RaZberry and x11vnc starts automatically.
******************************************************************************************************
To change the current x11vnc password (raspberry), type the following line in a terminal window.
x11vnc -storepasswd
The VNC Viewer can be found at www.realvnc.com
******************************************************************************************************
SSH is enabled, user "pi" and password "raspberry".
******************************************************************************************************
How do I upgrade NexaHome?
Type the following lines in a terminal window (replace NexaHome_4.0.9.jar with the latest version).
cd /home/pi/nexahome
wget http://nexahome.se/NexaHome_4.0.9.jar
Also update the version information in the following file, run_nexahome.sh
******************************************************************************************************
How do I add/configure new devices?
This is done in TelldusCenter, restart NexaHome to get the new devices imported.
Sensors and groups are added by clicking on the 'Devices/Groups/Sensors: Add' button in NexaHome.
******************************************************************************************************
Can I operate Z-Wave power plugs using the NexaHome software?
Yes, if you connect a RaZberry to your RPi.
What is RaZberry?
RaZberry turns your Raspberry Pi platform into fully featured Z-Wave Home Controller. A little
daughter board module is just plugged on the GPIO of the Raspberry PI board (not blocking a
USB port).
Please find more information at http://razberry.z-wave.me/
******************************************************************************************************
How do I install/update the RaZberry software?
Type the following line in a terminal window.
wget -q -O - http://razberry.z-wave.me/install | sudo bash
Open NexaHome 'Config' tab, enter the RPi IP address and portnumber 8083 at the 'Z-Wave.Me' section.
Close NexaHome (File -> Exit).
Restart your RPi.
Configure the RaZberry by entering the following url in the RPi web browser (without any spaces).
http://localhost: 8083
Set a new password, give the username 'admin' and type your new password the next time you access
the url.
******************************************************************************************************
How do I clone/make a backup of the SD-card to a new with the same size, smaller or bigger?
Connect a SD-card adapter with a new memory card to one of the USB ports.
Start the backup by typing the following lines in a terminal window.
cd /home/pi/rpi-clone
./clone-to-usb-sd-card.sh
******************************************************************************************************