Re: ELJR-1000 och Andersson PRS 2.1 Projektorduk
Posted: Fri Mar 17, 2023 9:45 am
Jag lyckades få min projektorduk under kontroll utan någon lödövning. Följande inlägg antyder att det finns en adress på fjärren enligt hur PCBt i fjärren är monterat. Min fjärr ser dock inte ut så, utan har en adress som är programmerad vid produktion i ett HS1527 (http://sc-tech.cn/en/hs1527.pdf). Det man får göra är att skapa en brateck remote med en påhittad adress och sen lära vägg-kontrollen att acceptera den nya fjärren också. Alltså,
* Skapa en brateck remote control med valfri adress
* Håll in STOP på väggkontrollen i fem sek tills ett pip hörs
* Tryck på valfri "knapp" på den nyligen skapade fjärren
* Profit
Nedan följer en instruktion från Aliexpress för kontrollen:
Installation and use:
Installation: fastening button and then wiring according to the drawing (professional installation is required).
Use: when connected to the power, you hear a short three sound, it means that no learning content in the remote control; press any key within 8 seconds and then hear sirens, youcan use it normally. (factory debugging have been completed, generally no need to do this step).
If you want to learn more remote controller, please press the STOP button more than 5 seconds after heard two short sound , and press any button remote control handle, when heard sirens means learning success. Using this method to study multiple remote controller to control the machine.
If you want to remove the remote control is being learned, please press the STOP button for more than 15 seconds, when you hear three short sound, it indicates the content has been removed. In accordance with the above method to study the controller again.
* Skapa en brateck remote control med valfri adress
* Håll in STOP på väggkontrollen i fem sek tills ett pip hörs
* Tryck på valfri "knapp" på den nyligen skapade fjärren
* Profit
Nedan följer en instruktion från Aliexpress för kontrollen:
Installation and use:
Installation: fastening button and then wiring according to the drawing (professional installation is required).
Use: when connected to the power, you hear a short three sound, it means that no learning content in the remote control; press any key within 8 seconds and then hear sirens, youcan use it normally. (factory debugging have been completed, generally no need to do this step).
If you want to learn more remote controller, please press the STOP button more than 5 seconds after heard two short sound , and press any button remote control handle, when heard sirens means learning success. Using this method to study multiple remote controller to control the machine.
If you want to remove the remote control is being learned, please press the STOP button for more than 15 seconds, when you hear three short sound, it indicates the content has been removed. In accordance with the above method to study the controller again.