Hello,
I need to buy some low cost hardware: sireless solar siren and wireless perimeter sensors like these:
http://www.ebay.it/itm/SIRENA-WIRELESS- ... Sw-zxWoJUk
https://www.casasicura.it/sirene-antifu ... olare.html
https://www.casasicura.it/barriere-este ... oC2_vw_wcB
I see that they transmit wireless with 434 and 868 frequencies but I do not know the transmission protocol they use.
Can I use them with your receiver?
Have you some better products to suggest me (available in Italy)?
Thanks,
Mario
Is this hardware supported?
Moderator: Telldus
Re: Is this hardware supported?
Impossible to know. I haven't seen or heard of any alarm sirens that are compatible with the Tellstick range of products.
Here is a list of compatible and tested devices that works with Tellstick: http://www.telldus.com/products/compability
For best compatibility you should look for Z-wave products, but then you need to use the Tellstick ZNet.
Here is a list of compatible and tested devices that works with Tellstick: http://www.telldus.com/products/compability
For best compatibility you should look for Z-wave products, but then you need to use the Tellstick ZNet.
-
- Posts: 2
- Joined: Fri Mar 17, 2023 9:45 am
Re: Is this hardware supported?
Thanks for reply.
Let's forget the siren for now, I am more interested in wireless solar barriers like these:
http://www.ebay.it/itm/SISTEMA-ALLARME- ... xyu4dRr3hb
They are china made products that use 433 frequency and are compatible with all brands of cheap alarm systems.
So I guess their protocol is common.
I do not want a reply like "yes they are supported 100%" but I am asking for a reply like: "if you learn their code a software update can enable them".
Thanks again,
Mario
Let's forget the siren for now, I am more interested in wireless solar barriers like these:
http://www.ebay.it/itm/SISTEMA-ALLARME- ... xyu4dRr3hb
They are china made products that use 433 frequency and are compatible with all brands of cheap alarm systems.
So I guess their protocol is common.
I do not want a reply like "yes they are supported 100%" but I am asking for a reply like: "if you learn their code a software update can enable them".
Thanks again,
Mario
Re: Is this hardware supported?
Normally burglar alarm has a little bit more complicated protocol between sensor and alarm panel, just to ensure a more secure radio link.
But, if you can get some pictures from printed circuit board/chip type etc of the solar barriers you might get a clue to if the will work or not.
In this link you can see some example of alarm products from Ebay that have been tested.
http://tellstick-net.wikia.com/wiki/NON ... f_etc..%29#
You should not expect a software update from Telldus in order to support these products.
By the way, what Tellstick product(s) do you have and is it possible to buy Tellstick in Italy?
But, if you can get some pictures from printed circuit board/chip type etc of the solar barriers you might get a clue to if the will work or not.
In this link you can see some example of alarm products from Ebay that have been tested.
http://tellstick-net.wikia.com/wiki/NON ... f_etc..%29#
You should not expect a software update from Telldus in order to support these products.
By the way, what Tellstick product(s) do you have and is it possible to buy Tellstick in Italy?