Adding hardware constructed by me?

Moderator: Telldus

Post Reply
lukaszrzepinski
Posts: 3
Joined: Thu Jan 18, 2018 11:08 am

Adding hardware constructed by me?

Post by lukaszrzepinski » Thu Jan 18, 2018 11:08 am

Hi!
I have been developing things and own hardware with my own cloud or OpenHab software.
My very basic question here (because I am considering if it is possible to build HW compatible with TellStick) : is TS open so that I can add my HW?
I understand that it uses proprietary 433MHz protocol?

Thank you in advance
Lukas

etompau
Posts: 2331
Joined: Thu Jan 18, 2018 11:08 am
Location: Skåne

Re: Adding hardware constructed by me?

Post by etompau » Thu Jan 18, 2018 11:08 am

What kind of HW have you built? Is it receiving or transmitting equipment?
Perhaps you should take a look at Telldus developer site:
http://developer.telldus.com/wiki

lukaszrzepinski
Posts: 3
Joined: Thu Jan 18, 2018 11:08 am

Re: Adding hardware constructed by me?

Post by lukaszrzepinski » Thu Jan 18, 2018 11:08 am

hi
it is basically set of sensors, temperature, humidity, ground humidity, rain sensor, window open sensor - they are wifi based (ESP8266 wifi card) and so far I was connecting them to OpenHab.
Now I am thinking to do something similiar with Telldus but it seems that Telldus supports only Z-wave and 433Mhz for HW. Are those protocols open? I see in shops that some devices like sockets and sensors appeared with "Tellstick commpatible" stamp

lukaszrzepinski
Posts: 3
Joined: Thu Jan 18, 2018 11:08 am

Re: Adding hardware constructed by me?

Post by lukaszrzepinski » Thu Jan 18, 2018 11:08 am

Update, here is the project of self-made temperature sensor compatible with Tellstick Duo (over 433Mhz)

https://forum.arduino.cc/index.php?topic=211371.0

Post Reply