Controlling Electric Shutters?

Moderator: Telldus

Post Reply
moryoav
Posts: 33
Joined: Thu Jan 18, 2018 11:08 am

Controlling Electric Shutters?

Post by moryoav » Thu Jan 18, 2018 11:08 am

Is there any Tellstick-controlled receiver that can control electric window shutters? It will require two states - up and down...?

Thanks!

mickelin
Posts: 107
Joined: Thu Jan 18, 2018 11:08 am

Post by mickelin » Thu Jan 18, 2018 11:08 am

You can use any On/Off switch for this. I use
http://www.nexa.se/LCMR1000Relamottagare.htm
for curtain and movie screen up/down control. You need two switches and a relay. (One switch for power on/off and one for up/down)

Great work on the MP plug-in by the way!

moryoav
Posts: 33
Joined: Thu Jan 18, 2018 11:08 am

Post by moryoav » Thu Jan 18, 2018 11:08 am

mickelin wrote:You can use any On/Off switch for this. I use
http://www.nexa.se/LCMR1000Relamottagare.htm
for curtain and movie screen up/down control. You need two switches and a relay. (One switch for power on/off and one for up/down)

Great work on the MP plug-in by the way!
Thanks! So with your technique I need two switches and a relay, but I also found this receiver:
http://www.coco-technology.com/manuals/SUN-500_EN.pdf

Which seems like a simpler solution, no? Will this device work with Tellstick?

micke.prag
Site Admin
Posts: 2242
Joined: Thu Jan 18, 2018 11:08 am
Location: Lund
Contact:

Post by micke.prag » Thu Jan 18, 2018 11:08 am

This will probably work with TellStick. We haven't tried it so I cannot say for sure.
Micke Prag
Software
Telldus Technologies

Jean-Julien
Posts: 34
Joined: Thu Jan 18, 2018 11:08 am

SUN 500

Post by Jean-Julien » Thu Jan 18, 2018 11:08 am

I tested switch SUN 500 to make function shutters.
Tellstick orders it without problem.
Knowing that it is necessary to send the same signal to start and stop, it should be regulated the programs so that they send only one order if not the shutter starts and stopped at once.
Cordially

Post Reply