TellStick Net and signals from wall switchs

Moderator: Telldus

Post Reply
jnsfi
Posts: 9
Joined: Thu Jan 18, 2018 11:08 am

TellStick Net and signals from wall switchs

Post by jnsfi » Thu Jan 18, 2018 11:08 am

Hi!

Can TellStick Net recognize a signal from the wall switch (Nexa WST-512) and then send a signal to the receiver (Nexa ECMR-250)?
My scenario: I press wall switch -> Tellstick Net recogizes it and sends command/commands to receiver/receivers.

This kind of linkage would be really nice - then Telldus Live would know if lamp are turned off with wall switch. :)

rhoddas
Posts: 65
Joined: Thu Jan 18, 2018 11:08 am

Re: TellStick Net and signals from wall switchs

Post by rhoddas » Thu Jan 18, 2018 11:08 am

jnsfi wrote:Hi!

Can TellStick Net recognize a signal from the wall switch (Nexa WST-512) and then send a signal to the receiver (Nexa ECMR-250)?
My scenario: I press wall switch -> Tellstick Net recogizes it and sends command/commands to receiver/receivers.

This kind of linkage would be really nice - then Telldus Live would know if lamp are turned off with wall switch. :)
Yes

jnsfi
Posts: 9
Joined: Thu Jan 18, 2018 11:08 am

Re: TellStick Net and signals from wall switchs

Post by jnsfi » Thu Jan 18, 2018 11:08 am

How? :D

Dowser
Posts: 44
Joined: Thu Jan 18, 2018 11:08 am

TellStick Net and signals from wall switchs

Post by Dowser » Thu Jan 18, 2018 11:08 am

Possibly by using custom firmware. It's not supported by Live.

rhoddas
Posts: 65
Joined: Thu Jan 18, 2018 11:08 am

Re: TellStick Net and signals from wall switchs

Post by rhoddas » Thu Jan 18, 2018 11:08 am

jnsfi wrote:How? :D
Oops - I didn't see that it was a Tellstick Net you asked about. In that case it much trickier I think

jnsfi
Posts: 9
Joined: Thu Jan 18, 2018 11:08 am

Re: TellStick Net and signals from wall switchs

Post by jnsfi » Thu Jan 18, 2018 11:08 am

OK. This would be a really nice feature to Live. :)

grrrmml
Posts: 1
Joined: Thu Jan 18, 2018 11:08 am

Re: TellStick Net and signals from wall switchs

Post by grrrmml » Thu Jan 18, 2018 11:08 am

Hi,
I just want to put this back to focus, because I'm wondering if it was possible to control an intertechno self-learning switch with BOTH hardware-remote (non-code-switch) AND Tellstick Net (in my case via RemoteStick) in parallel.
That means either finding the (generated randomly once?) code of the remote or have tellstick forward such to known self-learning switches. Does anybody have knowledge about it?
Kind regards, grrrmml
Last edited by grrrmml on Wed Feb 13, 2013 11:00 pm, edited 1 time in total.

jorang
Posts: 259
Joined: Thu Jan 18, 2018 11:08 am
Location: Norway

Re: TellStick Net and signals from wall switchs

Post by jorang » Thu Jan 18, 2018 11:08 am

Can comfirm that Intertechno ITL-500 and ITL-1000 functions with Net/ Live!
______________________________
Mvh/ BR JoranG

Post Reply