My forum

Hi The last few days I've had some trouble with my Tellstick and switches. It started with a nwr-1000 that stopped working. The switch is triggered by a motion detector, and is connected to an existing wall-switch. My gf plugged a hairdryer into the socket in the bathroom lamp that the switch contro...

That is my thought as well. I don't have any transmitters with batteries, apart from wireless wallswitches and motion detectors. None of these are registered in Telldus Live, but can they screw up the Tellstick anyway? I thought the signals from these went straight to the switches and not to the Tel...

Ok, thank you. With transmitters you mean remote controls, motion detectors, wireless wallswitches, and not the switches that are connected to the lamps? My tellstick has detected a couple of temperature sensors that are not ours. I guess it could be one of these too..... I will look at all my trans...

Hi I have a nexa switch wmr-1000 which is switched on and off by a motion detector, with 5 minutes delay. The problem is that the lights turns on right after it has been turned off by the the motion detector. It does not happen every time, but often. Any ideas why this happens? Is it the motion dete...

Hello I have a Proove motion detector paired to a Telldus dimmer for turning on the lights in the hallway. The light goes on without issues, but then it starts to dim the light up and down. The light goes from strong to nearly off, and back up again. My hope was that the motion detector would turn t...

Thank you for the reply. I am new to the whole smarthouse thing, so I would appreciate if you could tell me how the event should be set up? I tried to connect a Nexa wireless wall-switch with dimming to the same receiver, but that did not work either. It turns the light on but not off, and the same ...

UPDATE
I did find the culprit, and it was like etompau said; a transmitter in form of a motion detector that was constantly sending. I changed the batteries and it has worked since.

I tried using events instead of connecting the motion sensor to the switch directly, but the delay was too long. I was through the hallway before the light came on. I solved it by connecting a on/off switch in the lamp, and paired it with the sensor. As long as the switch on the wall is on it works ...

I am pretty new to Tellstick and the whole smarthouse thing. So far I have bought different switches and hardware that does not work as I thought so I need some advice. I have a wall-switch which is divided in 3 on/off switches, which in turn controls 3 different lamps. I would like to control 1 of ...

Thank you again for the fast reply. In which cases would the WMR-252 be used then? And is there another solution?

I am having trouble with getting a lamp to work with the receivers. The setup is as follows. The lamp is a low-voltage lamp with a transformator built in. It is connected to a dimmer wall switch. I connected the wmr-1000 on/off switch with L and N from the roof on the correct side of the wmr-1000 an...

It is a KTB-105 35-105w transformer. Will it help to put the receiver before the dimmer switch instead of between switch and lamp? I can of course measure the voltage when the lamp is switched on and off before connecting the receiver.